Advertisement: Upload your ad
Recent Notes and Tags
Top Searches: • fanuc not ready • fanuc not ready alarm • takisawa • fanuc om not ready • fanuc 6m not ready • troubleshooting fanuc ot control • fanuc om not ready • takisawa fanuc • fanuc not ready • fanuc 6m • fanuc 0 not ready • takisawa forum • fanuc ot not ready alarm • fanuc series o m troubleshooting • fanuc 0m not ready • fanuc om • fanuc alarm not ready • fanuc o m not ready alarm • takisawa vmc • fanuc om not ready alarm • fanuc takisawa • not ready fanuc om • problem fanuc takisawa • fanuc om spindle • fanuc ot not ready • cable communication fanuc 0m • fanuc 0m not ready • fanuc 0 m not ready • fanuc controller not ready • fanuc 6m not ready • alarm spindle trouble fanuc om • fanuc ot won t power up • |
Takisawa Fanuc OM won't power upcnc-forum - Faunc
| Takisawa Fanuc OM won't power up I have a Takisawa VMC with OM control. The spindle seem to lose power while running a job and alarm buzzer went off. I was able to restart the machine and run spindle below 1k RPM. any higher will shut spindle down and set of buzzer. Thought it was the belt drive. The next day I turned the machine on in an attempt to change the belts. The CRT comes up not ready and the alarm buzzer goes off. I have checked quite power in, fuses and tried disconnecting the spindle sensor as there was a spindle sensor alarm on the spindle control readout. No luck. Anyone with any ideas? I would appreciate the help. |
| Hello Greg, If the spindle is topping inbetween then this problem seems to be of the sensor , please inform me if there is a sensor inside the motor or there is a external sensor. If there is a internal sensor then the gap between the sensor and the rotor is very critical if you have moved the sensor then its possible that it might not have been fitted proerply , its mostly a magnetic sensor |
| Hi Greg Pl confirm the al.no on the sp drive and check that the problem is with ort.sensor or sp motor sensor.As speed is not going beyond 1k it is related to the sp motor sensor only, remove the fan motor remove the cover below the fan motor, confim the gap between sensor and gear upto 0.1mm by filler gauge, check cable from sp drive to sensor u may get the problem , Shree |
| Dear Grej Sir, i have a Takisawa VMC with OM control. The spindle seem to spindle motor alaram intermittently.this problem is not regularly coming.i have checked the power cable & supply rating . please confirm me root cause of this problem. i am requesting from pune (india) |
Reply Options Share your opinions, advice, questions or comments on this post. | You must a registered user and logged in to use this feature: It is quick easy and offers many advantages when using our site. |
Social NetworkingShare this with your friends on facebook, twitter and Google+ | | Social sharing because it feels good:
| |
|
Tags and TaggingTags help organize related posts and resources by topic. | |
|
Computer Numerical Control
